The process of installing a magnetic flyscreen is very easy.
Step1: Clean the door frame with a damp cloth.Walt for few seconds until door frame is dry.Measure the center of the top door and mark center with pencil
Step2: Place the screen on the floor with velcro side fadng up.Cut roll of velco into equal lengh with the top
Step3: Attcah the velcro strips to top and each side of screen door without removing the white backing tape.
Step4: Peel off the white backing paper from top side of the screen only,do not remove backing paper from sides at this step.
Step5: Hold the center of the screen door to the center of the door frame and make sure there is no room under the bottom of screen,but high enough not to drag on the ground.And then stick screen,starting ffom top center(slightly higher than top sides) and working outward.Remove white backing paper from two sides of the screen ,stick velcro to door frame staring from top to botton.keep a light tenslon across the screen,but allow it to loose enough for magnets to close without gap.
Step6: Check and make sure the screen opens and closes without gaps.Make adjustments if necessary.For an extra support,you can use the provided thumb tacks on wooden door frames.We recommend adding at least 2 tacks in the center of the top velcro,and 2 tacks on each side of the top velcro(as seen in the picture above).The remaining tacks can be located to the sides of the velcro equally. Now you can keep your door open and enjoy the fresh air without bugs.
Leave a comment